The WCT is a caliber-specific case trimmer that indexes off of the shoulder of the case. It has a chamber cut in the trimmer body, and an adjustable endmill to control the case trimmed length. To use, you must size your brass prior to trimming. The more uniform your sizing, the more uniform the case trimmed length. The trim length has approximately .225” of adjustment, to accommodate any custom length you would like.
Adjustment

This is pretty straight forward. Loosen the endmill-retaining set screw. Then insert a case that is trimmed to the length you want your cases.

While keeping the case seated into the trimmer body, move the endmill into the body until it makes contact with the case.

Retighten the set screw to hold the endmill in the proper position. It doesn’t take a great amount of tension to hold the endmill in place.
Ordering
Please visit the HMR Shop page or ebay page to order!
The WCT only trims to length. It does not chamfer inside or out like some other very nice, high capacity trimmers, but it costs $20, not $300+. You can operate the WCT by hand, but it works exceptionally well with a drill press or cordless drill motor. The faster the better.
The WCT is available in many calibers. You can choose from the list on the "Shop" page.
Other calibers can be made on request.
The WCT only trims to length. It does not chamfer inside or out like some other very nice, high capacity trimmers, but it costs $20, not $300+. You can operate the WCT by hand, but it works exceptionally well with a drill press or cordless drill motor. The faster the better.
The WCT is available in many calibers. You can choose from the list on the "Shop" page.
Other calibers can be made on request.